Insight Low Iron Magnetic Glass Whiteboard Gloss White
The marker board comes in a variety of sizes from 17.72” x 23.62” to 27.24” x 94.49”. Boards are made of 0.15” thick, tempered glass. Boards are available in gloss white, gloss black, low-iron white, matte gray, red, orange, yellow, green, blue, and navy. Visionary glass boards are backed with 20 Ga steel to allow for the attachment of rare earth magnets.
MOUNTS:
Silver finish wall mounts come standard with gloss white, gloss black, and hierarchy-colored boards. The mounts are made up of a 1” diameter machined stainless steel cap attached with an M6 x 9mm stem to a 1” diameter cast zinc board support. This assembly is attached to a stamped sheet metal back plate with two M4 x 6mm countersunk screws. Each mount is attached to the wall with an M5 x 34mm pan head screw and comes with masonry and drywall anchors. A set of four mounts come with boards 47.24” x 47.24” and smaller, a set of 6 mounts for 47.24” x 70.87” boards, and a set of eight mounts for 47.24” x 94.49” boards.
The Aluminum Exo Trays offer a 12 Ga aluminum 2.25” x 20” detachable tray. The tray rests in a 23.75” long tackless display rail. A T-slot in the tackless display holds two M6 x 10mm bolts. These bolts screw into two 12mm diameter 2.5” long standoffs which slot into 8” longboard supports. These board supports, as well as two on the top side of the markerboard attach to the wall with two M5 x 34mm pan head screws each. Masonry and drywall anchors are included. One exo tray is used on boards 35.43” x 47.24” and smaller, two are used for boards 47.24” x 70.87” and larger.
Low-iron whiteboards and matte gray projection boards come standard with two concealed Z bars that engage with two punched clips on the back of the markerboards. Z bars are 16 Ga aluminum bars of varying lengths attached to the wall with M5 x 34mm pan head screws. Masonry and drywall anchors are included.