Cover with 1/4" square brass flange (lift off door)

The FSR FL-700-BSQ-C Cover with 1/4-inch square flange is designed for FL-700 floor box. This cover meets the UL scrub water requirements for tile and carpet installations. The sturdy 11 gauge steel cover is installed flush with the floor. When the box is not in use, only the elegant, hand mitered carpet edge is visible. This model is finished in brass.

Pass cables through the box without interfering with the various connectors

The FSR FL-700 floor box is designed for conference rooms, auditoriums, classrooms, etc. where it may be necessary to pass cables through the box without interfering with the various connectors. This simplifies installation of wiring when a group of boxes must be connected in series. The pass thru route is front to back. The FL-700 is used on carpeted floors over concrete. It provides a practical and safe solution for easy access to cables and connector plates.

The lift-off section of the cover allows full access to internal cables and connector plates while a smaller, hinged trapdoor flips back to create a cable exit. All cables can be stored within the box when they are not in use, allowing unencumbered travel in the area.