| Model: CDA-4 Specifications |
| Description |
1 x 4 Computer distribution amplifiers |
| Video Input |
| Number/Type |
1 RGBHV, RGBS, RGsB, RsGsBs, component video,S-video, HD - 15 female connector |
| Impedance |
75 Ohms |
| Output Offset |
+/-20 mv |
| Level (nominal) |
Analog 0.7V p-p |
| Level (maximum) |
2V p-p |
| Equalized Video Output |
| Number/Type |
4 or 6 RGBHV, RGBS, RGsB, RsGsBs, component video, S-video |
| Connectors |
4 or 6 HD - 15 female connectors |
| Bandwidth |
Supports up to QXGA (2048 x 1536 @ 60Hz) This performance data is based on the CDA-4/6 plus the specified length of WP8255 (West Penn) cable. 150' cable 162 MHz (-3 dB) 0-143 MHz 0.5 dB flatness with a full amplitude (0.7V p-p) signal applied. 150' cable 305 MHz (-3dB) 0-256 MHz 0.5dB flatness with a small amplitude (0.2V p-p) signal applied. |
| Level (nominal) |
Unity |
| Impedance |
75 ohms |
| Design Cable |
West Penn WP8255 or equal |
| Video Output |
| Number/type |
4 (CDA-4), 6 (CDA-6), RGBHV, RGBS, RGsB, RsGsBs,component video, S-video |
| Connectors |
All female HD - 15 |
| Bandwidth |
375 MHz @ -3 dB (typical) fully loaded with a 0.7V p-p input signal |
| Flatness |
0.5 dB to 297 MHz (typical) fully loaded with a 0.7V p-p input signal |
| Gain |
Unity (buffered) |
| Impedance |
75 Ohms |
| Sync |
| Input level |
TPL 2.0V minimum |
| Output level |
5.0 Vp-p into Hi-Z, 2.4 Vp-p into 75 ohm |
| Delay Time |
8nS |
| Rise & Fall Time |
2.5nS |
| Input Impedance |
475 ohms |
| Output impedance |
75 ohms |
| Polarity |
Positive or negative |
| Horizontal frequency |
15 kHz - 200 kHz |
| Vertical frequency |
50 Hz - 150 Hz |
| General |
| Power |
120VAC, 50/60 Hz, 9 watts, wall plug-in with locking connector |
| Enclosure |
Metal, 8.5"W x 4.75"D x 1.62"H (1/2 rack unit) |
| Weight |
1.6 lbs. Rack mounting kit is supplied. |