| Rated power |
- 2 x 2 ohms:
- 3790W per channel @ 1kHz 1% T.H.D. both channels driven
- 2 x 4 ohms:
- 2030W per channel @ 1kHz at <0.1% T.H.D. both channels driven
- 2 x 8 ohms:
- 1170W per channel @ 1kHz at <0.1% T.H.D. both channels driven
- 1 x 2 ohms:
- 3900W @ 1kHz at <0.1% T.H.D.
- 1 x 4 ohms:
- 2400W @ 1kHz at <0.1% T.H.D.
- 1 x 8 ohms:
- 1300W @ 1kHz at <0.1% T.H.D.
|
| Minimum load impedance |
|
| Maximum RMS voltage swing |
|
| Frequency response |
- 2 x 2 ohms: <0.5% @ 3390W per channel from 20Hz-4kHz, decreasing to 3100W @ 20kHz
- 2 x 4 ohms: <0.1% @ 1850W per channel from 20Hz-20kHz
- 2 x 8 ohms: <0.1% @ 1170W per channel from 20Hz-10kHz, increasing to 1350W @ 20kHz
|
| Input CMRR |
|
| Voltage gain |
|
| Crossover |
- 100Hz switchable 2nd order high pass and 3rd order low pass per channel
|
| Crosstalk |
- >-60dB @ 1kHz at 1000Ws power @ 8 ohms
|
| Hum and noise |
- >-100dB, "A" weighted referenced to rated power @ 4 ohms
|
| Slew rate |
|
| Damping factor (8 ohms) |
- >200:1 @ 20Hz-1kHz @ 8 ohms
|
| Phase response |
- +15 to -85º from 20Hz-20kHz
|
| Input sensitivity |
- 2.25V ±3% for 1kHz 4 ohm rated power
- 2.20V ±3% for 1kHz 2 ohm rated power
|
| Input impedance |
- 20k ohms balanced
- 10k ohms unbalanced
|
| Current draw |
- @ 1/8 power:
- 1348W @ 2 ohms
- 757W @ 4 ohms
- 504W @ 8 ohms
- @ 1/3 power:
- 3185W @ 2 ohms
- 1654W @ 4 ohms
- 907W @ 8 ohms
|
| Cooling |
- 3 temperature dependent variable speed fans
|
| Controls |
- 2 front panel attenuators
- Crossover select switch for High Out, Normal and Subwoofer
|
| Indicator LEDs |
- 2 ACL (clip limiting)
- 2 signal presence
- 2 active status
- 2 temp
- 2 DC protect
|
| Protection |
- Thermal
- DC
- Subsonic
- Incorrect loads
- Under and over voltage
|
| Connectors |
- Inputs: Neutrik Dual Combi 1/4" XLR
- Outputs:
- Dual 1/4" signal patch
- Neutrik Speakon Dual 4-pin twist-lock connectors
|
| Construction |
|
| Dimensions |
- (LxWxH) 17.5 x 19 x 3.5" (444 x 482 x 89mm) behind front panel + 0.75" for front panel
|
| Net weight |
|
| Gross weight |
|
| Warranty |
|
Rated power readings made with BW: <10Hz-22kHz. All power measurements made at 120 VAC. 2 ohm power is time limited by circuit breaker. Input power requirements: 120 VAC, 60Hz, 5A.
* Net weight does not include power cord. |